Easton 5.0 5mm Match Grade Fletched Arrow w/ HIT & Collar

Engineered for modern bowhunters who want blistering speed without sacrificing structural integrity, the Easton 5.0 is the lightest 5mm carbon hunting shaft Easton has ever produced. Built on Easton’s Match Grade System with ACU-Carbon technology and Five-Point straightness control, these factory-fletched arrows deliver class-leading consistency, ultra-clean flight, and the ability to build truly high-FOC hunting setups.

Why it hits above its class

• speed first design: low grains-per-inch across spines keeps trajectory flat and sight tapes tight, even at extended ranges
• extreme foc ready: lightweight shaft pairs with included inserts and collars so you can push more mass up front for deeper penetration and broadhead control
• acu-carbon uniform spine: seamless layup, single mandrel production, and continuous-feed process for consistent dynamic reaction around the shaft
• five-point straightness: measured and controlled along the full length for true “beyond straight” performance
• match grade build: precision component fit, tighter tolerances, and repeatable accuracy shot to shot

HIT + Collar system (included)

• HIT (Hidden Insert Technology) aligns the broadhead ferrule directly to the shaft’s ID to improve concentricity and broadhead flight
• 5mm HIT collars add frontal reinforcement to protect the shaft mouth on impacts and during target removal
• microlite 5mm nocks reduce rear mass to help maintain forward balance and efficient arrow recovery

Factory fletched for clean flight

• AAE Hybrid 26 vanes set in a right-hand helical for rapid spin-up and broadhead stability
• ready to cut, square, and tune; just set length, install components, and sight in

Specifications

• construction: high-strength carbon fiber (ACU-Carbon)
• diameter: 5mm / .204" ID
• length: 32"
• straightness: ±0.001" (beyond straight)
• archery style: hunting
• fletching: factory helical with AAE Hybrid 26 vanes

Spine chart (gpi)

• 200 spine — 10.6 gpi
• 250 spine — 9.5 gpi
• 300 spine — 8.4 gpi
• 340 spine — 7.5 gpi
• 400 spine — 6.8 gpi
• 500 spine — 6.2 gpi

What’s included

• Easton 5.0 (5mm) Match Grade factory-fletched shafts
• HIT inserts and 5mm HIT collars
• 5mm Microlite nocks
• AAE Hybrid 26 vanes (factory helical)

Pro tips

• for fixed-blade broadheads, prioritize higher FOC (insert/collar + heavier head) to stabilize flight and improve penetration
• square both ends after cutting; dry-fit HIT inserts to verify perfect broadhead alignment before final epoxy set
• spin-test every finished arrow; minor point shaft indexing can further tighten groups